Apr 20 2011, 04:58 AM
I've got an DuoX2 cromwell that I just installed and it is not working. I tried to find a pinout for the board and cannot find it. I would like to test for continuity between my header and the actual pins on the board (like where you would do a soldered/wired mod chip install). Anyone have these? Are they in the stickies? Thanks!
Apr 20 2011, 05:14 PM
It isn't that difficult. Just follow the trace on each of the LPC pins to their first test pad or component. Use that point for your test.
Apr 21 2011, 01:34 AM
I was hoping for a picture like this (my old eyes have a hard time seeing this stuff):