i just bought an x2.3 lite +, and i installed it, and got the usb power adaptersupplied so all the lights were on, or so until i turned the modchip on, the minute i turn the modchip on, the green light goes off, and the xbox frags...ppl said it was my lpc ports that they were dirty but i doubt it, cuz why would that make the green light go off....any suggestions at all???

could it be the bios??? i know a bad bios makes it frag, but i didn't flash the bios yet, i got it from smt, and the greeen light on the chip goes off, would the green d0 light on the chip go off if it's a bad bios

frags are usually caused by the lpc ports, clean them

also check if your modchip is aligned

Never used a 2.3 lite +, but on a 2.2 lite + the green light on the chip is supposed to go off when the chip is enabled.

As far a the frags, those suckers can be pretty hard to get llined up.

Also I have heard that it is important to make sure you have a good ground with those 2.3's. Check the tut on installing there's a section on grounding the chip.

how do i clean the lpc ports, and i think it is aligned, cuz the green light shows that the d0 is, and i checked the lpcs, is there a way to clean the lpc ports without killing them like with a razor, cna i just cleant hem with my hands, cuz i already tried that

could the frags be becuzof a bad bios it came with, i have a programmer?

and where can i find tuts on 2.3s, i've chexcked system-mods.com, and i've looked at all of theirs

well how did you install your chip with what tutorials?

Well, I've installed 3 X2.3+ chips this week... I had some problems with one of them... they sent me a bad USB board. Couldn't get BLUE lights on. (Had to splice and solder power straight to Controller port wires to avod waiting )

If it reboots 3 times then FRAGs you need to get your D0 aligned. (green light may still come on, tho). I had to also use my dremel to elongate the screw hole (TOWARDS THE CHIP) to get one installed. I could plainly see that the D0 spiked pin was too far FORWARD. This completely fixed the problem! This was a version 1.1 . Also may sure of the obvious... is your switch set for the correct version?

BobDobbs

i tested my version, and from what i tested i'm a version 1.0, but maybe they're wrong, if i switch the switch will i screw up my xbox if it's wrong?