aight some ppl asked me to post some pics... so here they are!
first i drilled 4 holes using a 5/16 drill bit for each of the feet. then you have to make sure that the holes in the metal case allow tha LEDs to go in tha feet. i think i drilled 2 extra holes in tha metal n just expanded 2 existing holes. for the holes under tha power supply, just cut out squares in the black plastic thing.
it wasnt tha cleanest cuts but they work
anyway, after those were done, i need to place the wires flat so that tha mobo n tha power supply can fit. i didnt have hot glue so i used electrical tape.
the LED feet come with a on/off switch which i decided to place on the back of tha case.
now that im done, i got too many cords here n there so it wont close completely
... so it looks like this
hope this helps you guys... it really wasnt hard at all, just a lot of work. pm me if you need to ask more questions.