i am currently putting 15 always on leds, and maybe 4 rumble leds

i currentl have each led connected to 2 wires, and a resistor

so thats alot of these wires

i tried connecting each pos end to a a resistor then to the pos source

and the neg ends togeather to neg source, but it was dim as shiat

any tips???

im not a newb, i have been doing mods for some time now, i just never took
an electronics class

i have done dual port leds mod, eject leds, jewel, rear fan etc;

so none of this



and do i need a resistor for the rumble leds too

Run a LONG wire through all of the positive legs of the LEDs and then a LONG wire to each of the ground legs. Then attach a proper resistor (maybe like 22ohm), to the positive wire and solder that to the mem. card pin on the right and solder the ground wire to the pin on the left!

do what he says he knows what hes talkin about