Jan 5 2003, 03:25 PM
I want to fit a switch to my Xecuter2 modchip. Some sites say it should come with one, but mine didn't.
I don't think aquiring a switch will be difficult, but where does it go?
Does anyone have an installation diagram for where the switch goes?
Jan 5 2003, 03:53 PM
mine didnt come with one. I'm installing it atm I would guess you could just put a switch on the BIOS enable jumper ??
Jan 5 2003, 07:40 PM
Just get any SPST switch from Radio Shack or whatever. You can then just solder wires from the two leads on the switch to the two poles of the middle jumper on the x2 lite.