Hangman021
Jul 3 2004, 08:01 PM
I am using the solderless adapter to install my Xenium. But in getting everything properly lined up, I have managed to strip out the mounting hole, so now I can't tighten the adapter down. Anyone have any suggestions on a way that I can fix this?
Thanks in advance
christineyoung
Jul 4 2004, 01:15 AM
Suggestions:
1) use wider screw
2) drill hole through xbox and use a nut and bolt
3) use locktight and screw
4) solder in pin header and forget about the solderless adapter
5) Don't bother using a modchip, j/k
spilt
Jul 19 2004, 03:29 AM
| QUOTE (christineyoung @ Jul 4 2004, 03:15 AM) |
Suggestions:
1) use wider screw
2) drill hole through xbox and use a nut and bolt
3) use locktight and screw
4) solder in pin header and forget about the solderless adapter
5) Don't bother using a modchip, j/k |
What size should you use? For it to fit nice and snug.... My xbox has been sitting here waiting to be used for a couple of weeks now. Please help....
silentsnake
Jul 19 2004, 03:43 AM
just get a screw big enough that will be snug in the hole you stripped out and tighten it down.
spilt
Jul 19 2004, 07:01 AM
I just wanna make sure what size. I have no extra screws around that would fit. If anyone knows what would for sure work, could they tell me?
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.