Is there a discrepancy between these two sets of instructions?
TeamXecuter's 2.3B Lite Pin Header Install
XBox-Scene's Modchip Diagram Instructions
Looking at the picture of what is included in my kit, I don't *see* the wires shown in figure 14 of the XBox-Scene instructions (click here for direct picture). The XBox-Scene tutorial says that this step MUST be done on Xecuter2.3. Why then do the "official" instructions leave this step out?
BTW, I have either a v1.2 or v1.3 XBox. Thanks.
(If I left anything out, please ask.)
(Oh, and symptoms are that I'm not seeing any lights on the modchip... I suspect it's not getting any power... and my pin header chip is loose... I can wiggle it)