Ok...stoopid me, I tested a homebrew chip on an Xbox, worked, and decided to yank it out...yes I know...well after inspecting the board, 4 traces were lifted along with some pads. I tried to fix the traces. It's marked in blue in the picture. I'm not sure if it's good or not. Using a multimeter, how would I go about seeing if it was a solid connect or not. Also, point A16 goes through some sort of resistor?, is it okay not to go through that way? Is there any place on top of the board I can use, instead of the points on the bottom? To bypass the lifted traces. After I install back the chip, I get the GREEN/RED flashing. Fixable? Or am I just FUBAR.