Full Version: 2.6ce Lite Problem
Scenyx Entertainment Community > Xbox1 Forums > Modchip Forums > Team Xecuter Chips (Xecuter1, Xecuter2 & Xecuter3)
i just installed the 2.6ce lite chip on a 1.6 xbox, but it doesn't boot to the bios flash screen. with the chip off, the box works fine, with it turned on, the power flashes on and off a few times then the xbox turns red and nothing's on screen, can any help?
Wow.. turns off and on a few times then flashes red an green??
What could that be??
Sorry.. it's just the most common question asked here...
do some searches... it's called a Frag..
The 2.6 comes pre flashed with good versions of Flashbios.. So, I doubt it's a bios issue
If the xbox boots with the chip disabled, you have a good d0 connection
I'll bet you either screwed up the pin header or the LPC rebuild. Check it closely. Use a magnifying glass and a multimeter. You probably have a bad solder point somewhere.
What could that be??
Sorry.. it's just the most common question asked here...
do some searches... it's called a Frag..
The 2.6 comes pre flashed with good versions of Flashbios.. So, I doubt it's a bios issue
If the xbox boots with the chip disabled, you have a good d0 connection
I'll bet you either screwed up the pin header or the LPC rebuild. Check it closely. Use a magnifying glass and a multimeter. You probably have a bad solder point somewhere.
QUOTE(solo220 @ Feb 6 2005, 03:59 PM)
i just installed the 2.6ce lite chip on a 1.6 xbox, but it doesn't boot to the bios flash screen. with the chip off, the box works fine, with it turned on, the power flashes on and off a few times then the xbox turns red and nothing's on screen, can any help?
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.