i'm trying to flash X-ecuter 2 pro , i'm doing it as it says the tutorial http://www.xbox-scene.com/modchips/x-ecuter2_pro_flash.html , but instead of using the DB25 Parallel Cable (male->female) , i'm using RS-232C cable Male/female, but when i connect my PC & X2P-external addon with the DB25 Parallel Cable, and open the X-ecuter 2 BIOS Manager , it cannot locate the X-ecuter 2 pro in any port , Help PLEASE , i'm doing as the tutorial says, the xbox is on so The modchip has now power and can be flashed. all the switches are off , what could possibly be. HELPPP!!!!

Try plugging it in directly to the parallel port....

PM5K i just turn on the xbox with the switches on the on possition and the xbox load with the deafult bios , shouldn't it boot giving me an error cause X-ecuter 2 pro has no bios yet, i mean it shouldnt load with the default bios if all the swithces are on, right?

QUOTE (PM5K @ Mar 8 2003, 10:41 PM)

Try plugging it in directly to the parallel port....

How do you plug it directly into the parallel port if the chip is in the Xbox?

QUOTE (MGSnake19 @ Mar 8 2003, 03:47 PM)

PM5K i just turn on the xbox with the switches on the on possition and the xbox load with the deafult bios , shouldn't it boot giving me an error cause X-ecuter 2 pro has no bios yet, i mean it shouldnt load with the default bios if all the swithces are on, right?

Sounds like you soldered you're d0 point wrong..

I mean plug the external connector into your parallel port, you may have to remove the metal shielding from your external connector, and you'll likely have to put the Xbox very close to your computer.