finally got to sauder in the chip properly after a hard grueling effort (x2pro) but now I cannot flash teh bios because it says that verification failed. It does read the chip with the device manufacturing code, etc. and everything else checks out fine except when i try to flash it. Umm...anyone?
I actually get Verification FAILED at 000000 : Read  Expecting 
but this changes every now and then!
After flashing i get FRAG. so that means that all the points are on good right? So i guess i need a shorter parallel cable? it is a 6' one and my friend actually has been using it before. what now? any suggestions? I also set the port to EPP instead of bi-directional and that didn't help solve the problem.
Writing goes fine and read read fine...but the verification fails.