about the reset button on the controller. I install the momentary switch in the controller and I solder it to the ground and the power in the controller. Then in the xbox I take the yellow wire from one of the ports and I make it longer and solder it to the second point from the bottom on the power/eject assembly. Is this correct. Is there anything else to this mod at all. Do I need to do anything with the yellow wire I cut besides solder it to the power/eject assembly. What about the other half of the yellow wire I cut that is hanging out from the white plug on the end of the controller port. Where is a good placement for the swith an a controller-s.

I've seen people put it here before.

Probably gonna nuke your controller if you hook it up that way...

Here is my tutorial for the s-type switch... the switch has moved since this tutorial to higher up on the memory port and to the back port instead of the front (in case the headset is ever needed)...

http://www.blindbug.com/xbox/tutorials/default.aspx