I just installed my duox2 on a v1.6 xbox and it won't boot it just loads the normal xbox startup i used the lpc rebuild port but on the left side the red part came off its now white (look at the pic) o and 1 of the pins came out but i put it back on

someone plz help i got the chip to power up now but my xbox is now going yellow green yellow green then red green red green (keeps on doing that) plz help

anyone ???

From what I'm seeing, you didnt solder any of the LPC header points to the LPC rebuild. Also, wait atleast a day or so before bumping. Patience is a beautiful thing.

the pic above isn't my install.....i soldered everything lpc rebuild port,chip wires (Do,Bt)
and pinheaders but when i turn it on the chip light blinks red and the xbox goes yellow green,yellow green, red green,red gren goes on foreever i don't know how to fix this

If I understand right you lifted the half moon shape connectors at 2 points on the rebuild board.
If so you cant just put them back on. they will have fractured the trace underneath the PCB and could also have damegd the rebuild points underneath.
you will have to remove the rebuild board to check for damage underneath. repair the damage first then use another re-build board or wires to rebuild the LPC.
Warning ... you could do more damage if the board is not removed correctly. If you are unsure it may be best to get someone to take a look at it for you.

is there anyway to fix the trace ? or do i have to do wires now ?

I think you will have to do a wire install. You would need to wire the trace on the rebuild board anyway which would prevent it from sitting down right.

if i could do the pinheader and bt points you think i can do a wire install ?? ooo i wanna try to fix the trace on the rebuild board do i just put a wire to LAD2 then to the half cone shape part pin ??because that looks easier

If you just lifted that one trace, you should be able to just use a piece of wire to short between those two points if the trace isn't doing it. You can test those two points by pressing a multi meter on the points that the trace connects.

It sounds like you've wrecked the trace, but it's not too big of a deal, if it is only the trace on the LPC repair that you think you've damaged. Your description is a little obscure tho.

I just recomment that you manually solder a wire to that top header pin, fourth from the right to the point at the end of the trace.

Goodluck, and I hope that you solve your problem.

so is this what u mean (red is the wire)

Yes you can do that. is that the only one damaged then?
I thought you were refferring to LAD1 and LAD0

ya thats the only one damaged

k i did the wire thing but i still get red green always i looked at my points and for broken traces still not working plz help

ok this is messed up if i turn it on from the eject button it loads the normal dashboard but the chip is off if i turn the chip on it flashes red a green what is going on ???

K this is what its doing now....

No harddrive in = boots dash with eject button and open dvd drive (gives eror number 09)
= power button does not show video or sound and doesn't eject dvd
drive


with harddrive= eject button boots fine like no modchip in
= power button solid green light then turns orange (no video or sound)

anyone ?? i want to get this working i have been doing this for 2 days now lol