All right so I messed up real big, and it was stupid I knew what I wanted to do and clicked the wrong thing. So what I was trying to do was flash my bios with the new x2 5028 bios. For some stupid reason I ftp'd the v. 1.6 bios instead of the v.1.0-1.5 (I have v. 1.0). Well I went ahead and flashed my chip with the 1.6 (didn't realize it was 1.6 at this point). So after it was done it shutdown my xbox when I started it up I could hear the flubber, but I had no screen it is completely black. I don’t know where it is loading to after the flubber but im pretty sure it is going to error message. So my question is what are my options. Oh yeah I also tried using slayers v2.6 but I can't see anything so I don't know if it is loading. Is the chip just worthless now? Do I just need to get a new chip? Just let me know what my options are. I know im a dumb ass so lets keep those comments to a minimum. Thanks, Jared

What chip do you have? Have you try switching to another banks?

TSOP flash?

i have a 2.3b lite, and i don't have another bank

how do you tsop flash without seeing the screen?

You would be able to see the screen if you disconnect the chip . Then you can go about flashing the onboard bios or softmodding it . But if the shit is booting I have done this for you cause I am the man .

Note: this is for slayers v2.6 and for a +137g drive
After you let the disc boot ( cause it should just be a video issue all the data is booting )

down
down
down
down
a
a
down
down
down
down
down
down
down
down
down
a
left
a
wait until your xbox turns off and then power back on . Should fix your problem hope this works and you owe me a smiley if it does .

i'll give you one because i read this and thought we were talking about the mortal combat ultimate move. coinsidence? i think not