Jun 7 2005, 07:00 PM
Does anyone know what pins out the adapter are for power/ground?
Im trying to figure out why i can never get the led on my cham 1.5 to light up, or go mode 4 writable, even though everything else seems to work.
I'd like to make sure I'm getting power where power needs to be.
Jun 11 2005, 03:29 AM
If you have not done so, please check this guide : Chameleon LE/S P&E Installation Manual
. It may have the answers you are looking for as far as mode 4 is concerned.
Jun 12 2005, 03:29 AM
yeah, thanks for that, but i had those all taken car of.
Ive been able to flash the bios twice now, but only after a fight both times.
the LED still doesnt light up ever.
I was trying to see what i could test on the pins themselves to verify the chip was at full potential.
Jun 12 2005, 03:38 AM
I apologize for just pointing you at the manual, I guess I was misunderstanding what you are looking for. What version of motherboard does your XBox have? I assume you would know if it was a 1.6 to rebuild the LPC, but you also have to get your ground and power on a 1.5 board. Although I imagine if you had the 1.5 and had not done so, you would never have been able to flash the BIOS in the first place.
Jun 12 2005, 04:49 PM
Ok, I put my specs in my sig.
Dont apologize, your trying to help. I appreciate that.
Anyway, what I'm looking for is a pin-out diagram/schematic for the adapter thats soldered to the mobo. The adapter that the chameloen plugs into. I'm trying to see if everything is properly connected, no bad contacts/lifted tracks.
Specifically, I'd like to know what pins are power and ground for it. If anything can be checked and verified with a multimeter, that as well. I dont want to go poking around with a meter and risk messing up anything.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here