So in the past few days of looking and searching the figure out whats going on with this damn chip, I learned something today. The LED must be hosed on my Cham 1.5
I took things apart once again today and found the my E point wire has come off the resistor. So i undid the E+P points from the board and redid them to the wires. Switched to mode 4, booted normally, no LED. Tried yet again to Flash Bank 2 with Evox8+ and I saw my very first xbox bios flash progress bar. SWEET. It usually would just sit there at Erasing with no bar. Rebooted and success, the Evox logon was on the boot screen.
now I need to get the 137GB hard drive thing going on the this and I'll be set.
Thanks to those few who helped me the past couple of days, and thanks to the forums in general.