I don't keep it upright just for the picture. Wanted to do the front and right side of the HD-DVD with chrome vinyl but didn't want to buy a role, might do it later. The SMD LED in the HD-DVD seems to have two feet on each side does anyone no what exact SMD LED they use I would like to change that Blue to match my XBOX360.
Black and Chrome Wireless Controller to match XBox360
Red MANU Wireless Controller for playing FIFA
Painted HD Black with VHT Black Vinyl Dye
Black Case ( Dont remember where I bought it from, but they are everywhere now)
Window cut out by Llamma
Pentagram Jewel ( Don't remember were I purchased , but just google for xbox jewels)
Jewel lighting was a bare Cyglow ring that I put in UV LEDS ( Don't go this route, I had to rip half of it apart and it is still a tight fit above the heat shroud). Powered by alternate 12V source from the unused 3 pin header spot on the Mobo. I drilled mobo and put in a 3 pin fan power connector.
Hitachi DVD window kit - purchased from Llamma
I painted the DVD case Chrome
Clear fan shroud - purchased from Llamma. This allows the Blue to show through from the LED Fans in the back without the need for more lighting. I still might add more lighting on the other side though.
ROL - Red in Center, Blue Ring. SMD 0603 ( Digikey/Mouser/Llamma or any Electronic Warehouse)
Chrome Faceplate - Most likely from Llamma again, but I could have got it elsewhere.
Painted HD-DVD Black with VHT Black Vinyl Dye
Rear Fan - Talismoon Blue Led Fan ( Don't remember where I got it, You can get them anywhere now, Llamma is always a good source)