Mar 19 2006, 08:32 PM
I have a xbox that has a hard drive that's noisy and getting ready to die. I was thinking about replacing it with a notebook / laptop 2.5" hard drive just because it would quieter. I'll need an IDE adapter, which they sell on ebay for around $5, so that shouldn't be a problem; and I don't go on Live so locking the drive isn't necessary either. I've done some searching on the forums (as best as I could given the state of the search engine) and checked the tutorial sections, but couldn't find much of anything about this.
I assume it should work fine, but can someone confirm that this can be done?
The only thing that has me a little concerned is about how to mount the thing. They do sell 2.5" to 3.5" adpater rails, but looking at dimension it looks like they will be a little short to mate up to the existing holes in the hard disk carrier.
Mar 19 2006, 10:52 PM
It will work just like any other hard drive. So long as it is at least 8GB, you'll be fine.
Mar 20 2006, 12:10 AM
Possible, would work the same. As for mounting goes Not sure if laptop hard drives have screw holes in the bottom but you could always drill new holes to mount the hard drive. Never know it might even cut down on the heat issue inside the box as well.
Mar 20 2006, 01:54 AM
I picked up a laptop hard drive on ebay and will let you know how it turns out.
The Zep Man
Mar 20 2006, 11:45 AM
I did this with a quiet (4200rpm with 8MB cache) Toshiba 2.5" HDD. I mailed them and asked if their drives were lockable (since it's an softmodded Xbox) and they told me that all their laptop HDD's can be locked. I got two brackets for mounting the 2.5" HDD into an 3.5" HDD position. The only thing I needed to do was sanding some small parts on the bottom near the edge of the Xbox HDD tray. It fit perfectly.
After that I cut the tray so a 80mm fan could replace the stock fan. Now it is an extremely quiet box.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here