Right I've been given the task of chipping my friends(or maybe now x friend) xbox with a spider 1.1 chip. He has a 1.6b xbox .... although I've only just found it out. Anyway all the pins are set fine and the spiders LED comes on but the xbox FRAGs, thats a D0 problem right? Could it be anything else?? I've been doing some nosing around and I've read that there is a problem with the laquer - could this be it? If so any clues how to solve?
Anyway Cheers in advance for any replys
-How.

Check this out for troubleshooting:

http://www.hackdabox.com/spiderchip_squeeze.html

If you soldered, use his link at the bottom. Hope this helps :-\

Cheers for the link, I'll give it a go asap. As for soldering uh well thats what this chip was for as I hate soldering with a passion.
Cherrs again.
-How.