Aug 1 2006, 08:23 PM
I just put a new LT OPX onto my 1.6 board. I know it's installed fine, but it's fragging. What else can I do? It can't be the solder points. It can't...
Aug 1 2006, 10:10 PM
have you tried booting recovery mode?? Does that work?? Might wanna get out the magnifying glass and look at those solder points a lil closer. double triple check everything.
Aug 3 2006, 02:33 AM
Check those Solder points, if necesary carefully reheat the solder on the solder points. It worked for me!
Aug 3 2006, 05:09 AM
Did you do a pinheader install? or a direct solder to the bottom of the board? As much as you dont wanna believe it.. its gonna be an install issue. Check very carefully for a poor solder point or a bridged point somewhere that shouldnt be, perhaps even a missing component. I always recommend a pinheader install, even with an opx on a 1.6, it makes trouble shooting /upgrades that much easier.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here