I was wondering if anyone could help me with a little bit of troubleshooting concerning the xbox 360 being recognized by windows. Ive burned the 0800 ISO, however when I place it in my drive and let it spin up then turn on my PC, there is an issue. The bios says it fails to initialize the drive, and Windows subsequently freezes on boot. This same effect happens even if I dont put the disk in at all, so I can only assume its due to the disk not being burned properly, or the firmware not reading the disk properly. I have Xtreme v5.2 and a TS-H943A, and have tried two separate DVDs, one dual layer and one single layer, both burned on different drives at a slow speed. I cant think of what it could possibly be, and my next step is to go back to Xtreme 4.2, since many people reported success on that drive. That is unless anyone here has an idea what could be causing this issue.

moved to hacking forum,

rgds,soso

Strange, the motherboard BIOS should read the drive no matter if you put the enable0800 in your drive or not. Sounds like you may have something plugged in wrong or the drive is bad. Does it work in your 360?