I don't know if anyone else has this setup but I assume someone else out there would. I have a projector (not a rear projection) setup as my primary display and am wondering which display settings to set for Rock Band to work well. The projector is a DLP projector (Viewsonic PJ458D).

Still no help??

Why not use the manual calibration? Those pre-configured settings don't work at all.

I use the In Focus IN24 projector. The DLP cal setting seems to work perfect for me.

I was figuring that the presets might be a little more precise than my manual calibration. I did try the manual calibration and it helped to a point but I still think there are some issues, especially under expert. I also tried the DLP setting and that does seem to work ok as well. Is there a good way to tell if the calibration is correct if settings are relatively close to each other, that is they seem to work but are just a little off?