Jan 23 2008, 04:20 PM
Title explains it all, do you need to use a special tip and or iron for the D2C mods? Or just use the smallest tip you can find?
Jan 23 2008, 04:25 PM
Weller WLC100 with an ST7 tip. It's not most expensive but it's better than the crap radioshack sells. I start with the temperature as low as possible and raise it up until it melts what I need. Weller makes great irons and soldering stations, I highly recommend them.
Jan 24 2008, 12:09 AM
Weller WTCPT with a 700 degree screwdriver (!) tip. Yeah, the tip is as wide as about three pins of the D2C chip