I follow those steps exactly
from the text book
Turn on the Xbox 360 and wait 2 or more seconds, status toggles between 0x51 and 0xD1
this was going fine
Turn off the Xbox 360 and wait 2 or more seconds, status will stay at 0xD1.
this aslo was ok
and here is the problem
Turn on the Xbox 360, you should get a good drive status 0x73 and reading should begin automatically.
after i turn on the xbox360 it returns again to toggle between 0x51 and 0xD1 Without proceed with the last step which is 0x73 ,
The question is
Did I miss something while am doing the flash
Note that my benq drive is new and never been flashed before
and am using iprep101