Hi to everyone. i hope someone could help me get my wii back.

i have brought wii clip to go with the d2ckey. when i plugged it in it didnt work just gave me both lights solid on. {red +blue}

after hours of reading i decided to solderit on to the chip myself but then i have dropped bit of a solder onto legs not much at all.

then i tried with a copper wire in between the tracks and sucked up all of the solder however i must of pulled little too hard on the last track which ripped off.

is there any where i could solder this first leg to get my wii dvd drive workig at all?

any help will be appertiated.

thanks in advance

try tinning up the wire which u was gonna put on there, and then just solder it on as normal.

what should happen as thats happened to me before, the solder on the wire should secure itself to the leg and hopefully to where the leg should be connected to


p.s i live in the hertfordshire area...if your ur near, i could help if ya like

There's a alteranative point for that pin. Use a meter and confirm that it is actually lifted.