hey guys i want to install my stock HDD inside my 360 there is a nice tut on hear that i was following butt the pic that tell you where to solder your power and sata wire is not there. Dose any one have a pic of the pin out???

Here's a picture that has the Sata pinout:



I believe the pins above 6, 5, and 4 are all 5v and the pins above 3, 2, and 1 are ground, but you might want to check that with a multimeter or just us another 5v source.

ok that help but where do i solder my sata data cable what are the pins for that??? power is not hard to find but data pin out is hard with no tut anymore

you should check the tutorial in my sig


but that pic pretty much explanes the sata cable, there is 7 wires and 7 pins to solder to, they are numbered in that picture, #7 on the cable is on the side with the dip

Theres actually 8 wires, the center 2 are GND and combinded in the SATA connector to create pin 4. But you already know that ballz.




-CollinstheClown