Having issues spoofing benq as a lite-on drive. Got the key fine, saved the key fine with toolbox into ixtreme firmware. Flashed with flash32, it seem to go well, sad flash was successful. When I hook the benq back up, it just has a black screen and 1 red light blinking. The benq was previously hacked, dont know if that makes a difference. When I try to insert the key into iprep I get an error invalid firmare so I just used toolbox and dvddriveswap. Even used hex editor to manually enter the key, that didn't work either. Using connectivity kit v3 lite to do the job and VIA sata contoller card. The weird thing is I accidently had the xboxdrive off when flashing and it still said it was write success. So something isn't adding up. Any help will be much appreciated.

Thanks

hi mate this is going to sound like a ditch attempt but recently done a benq spoof
and had the same symtoms as you describe black screen or stuck on xbox 360 logo then after a while had a red light and then sometimes big screen with e64 on so i just changed both the sata connector and the dvd power cable for an older one and low and behold fired straight up and grafted spot on

Thanks for the info mate, I will give that a shot and report back with the results.

yea no luck with that mate, still dead in the water, thanks anyway