How would I go about doing this ?? I want an on/off switch for each vibration motor u think it could be done ?? Anyone help ??

Thanx in advance

just put a switch between one of the two wires going to the motor and apply 5v to it

Will you need a drawing?

why do you want that:|

QUOTE (TykSak @ Jun 26 2003, 10:25 PM)

just put a switch between one of the two wires going to the motor and apply 5v to it Will you need a drawing?

I would really apreciate it

QUOTE (hirme @ Jun 26 2003, 10:27 PM)

why do you want that:|

Some times i like vibration in games, sometimes I don't. and i'm too lazy to go to the game menus everytime

the forum was just down

oh you want to be able to disable the vibra

Well Ill whip up another pic but heres one for normal mode/always on

QUOTE (TykSak @ Jun 26 2003, 10:52 PM)

the forum was just down oh you want to be able to disable the vibra Well Ill whip up another pic but heres one for normal mode/always on

ok thanx if ur up to the challenge I'd appreciate the other pic

There you go


thats just for one of the motors you could take the two gnd wires connect them and put a switch between them (that would turn on/off both motors)

QUOTE (TykSak @ Jun 26 2003, 10:58 PM)

There you go thats just for one of the motors you could take the two gnd wires connect them and put a switch between them (that would turn on/off both motors)

so it goes like this ??

Red wire from vibration motor - one end connected to motor and other end soldered to a switch ??

??? if you could please describe where all the wires go in like idiot proof words i'm a n00b i just need some help if u could make a small tut or anything everything would be real great

thanx

Cut the two black wires.

Combine the two gnd (black) wires coming from the controller and connect them to the middle leg of your switch.

Combine the two gnd (black) wires going to the motors and connect them to one of the outer legs of your switch.

That would turn on/off both motors with one switch.

(Could someone verify this, thx)