Greetings, I have a CYGNOS V2 Rev F chip to install to a JASPER MO-Board.

First thing I noticed there is no ON/OFF switch

Second Do I need to solder the GND also? In the video that was not done.


I went ahead and soldered the chip to the MO-Board and all the quick solder points but no BLU LED comes on



Any assistance will be greatly appreciated

I can provide photos or whatever other information needed.
Thanks


*Edit: I checked the solder points and added my own switch. Now the chip works.
Running parallels desktop on a mac virtual windows recognizes the CYGNOS chip.



New problem toolbox wont run

rev F doesnt get a blue light and doesn't need a switch !! so most likely you just killed it!!

look at pic at cygnos site, NO SWITCH on there