So i was doing modding my friends drive. its a liteon 93450c. I performed the MRA hack and got the key. however, upon repairing the traces i think i may have shorted the drive, as for a split second there was a little spark coming from one of my solder points. I looked over the board thoroughly and it doesnt seem like anything is completely burnt out (like it did the first time i shorted one of these). the drive wont intro anymore and will only give status 0x80 in jungleflasher and dos. some help would be appreciated. thanks

we need a hi res picture of your work. also, check the flip side for burn marks.

alright ill make a picture tomorrow. i checked for burn marks theyre defintely not there. i hope u guys can see something i cant

i had a lite-on that was erased and stuck in status 0x80 the only way to get it out was to do the mra hack and re intro into vendor mode L-O erase wouldn't work in jf or dosflash

Eeeeerm...if you've got an erased Liteon then the key is gone. Why would you bother doing the MRA to dump the firmware?

i already had the key it was just stuck in 0x80 the only way i was able to get it out of 0x80 was to mra then intro with switch in pos 2