so im kind of new to flashing stuff but i read a lot b4 doing it.
i have a bit old xbox and it was inmy room sitting there for a while so i burned a new game and tried it out and the driver was reading as a dvd, but not the game. i tried gta4 and worked fine, so it was flashed.
i plugged in my pc and got on jungleflash and it was 1.1 so i decided to upgrade it to 1.6.

i have a vad6038 and i did everything right, i read, saved the key
did backup and put to write, but it didnt work, so i erased by mistake. Now the jungle dont detect it, the eject dont work and if i try to read, write or anything it says invalid status, i tried iprep and 360 usb drive and no sucess

can anyone help me?
all i want is to restore to the 1.1 i had or 1.6 since i still have the key and the bencfw.bin (orig)

Well first off you did not upgrade. You downgraded from the newer LT 1.1 to a now outdated old IX 1.6. You should have upgraded from LT 1.1 to LT 1.2


And it is also likely that your drives laser may be getting weak.

umm...bro...he meant ixtreme 1.1....not LT

try sending an intro,and power cycle.you should get the flash chip properties and write.

yea this xbox is back from 08 and the firm was ixtreme 1.1
'
i tried to do it in jungleflash, but on the i/o port i get "driver not detected" even if i do read,outro or intro , press ok and take off and on the powercord

i tried to do it in iprep, but when i do ben 1234567 12345 or dben 1234567 12345 it says bad command or invalid any shit.

i tried it in jungleflash on both my ports with no success
:/

any ideia?

only option is to whip out dosflash