I'm using the guide from the tutorials section of the site.

I am working on a version 1.0 Console. The photo in the guide shows R7D10 for the points that need to be bridged:



My board has R7D3 in that spot. Here is a photo of my board:



Am I missing something? I dont want to bridge the wrong points.

Anyone wanna help me out?

the pic from the guide is from 1.2 or later, not a 1.0 like yours. your picture shows the correct point

you can also check out the TSOP write enable pics linked in my sig

Thanks for the fast reply!

Also.

Are these the correct points on the back of the board that need to be connected with a wire?



Thanks again!

you can do that if you want, but its not necessary, theres a set like the ones on the top of the board that are right next to each other. the wire method is generally only used if youve already damaged the regular points

this pic shows both sets of points

Great! This should make things ALOT easier. Do I need to desolder the points after the flash or can I safely leave them connected?

no harm in leaving them connected (i always do)