done lots of em and shit happens lol this is one of a few times i pulled stdby clk pad repaired it as usual and proceeded to boot up the falcon Coolrunner glitches as usual with green light then the green light eventually stops and nothing comes up on screen.. tried a diff coolrunner same outcome..

i know stdby clk is repaired correctly cause the console powers on.

i flashed the console back to stock nand removed the CR and all the wiring yet it STILL sounds like the fans are resetting and results in rrod 0022

i can read/write the nand without issues so not bad flash.. perhaps a true 0022 ?

More than likely a short somewhere mate. Pictures of all the solder points would help, the usual suspect is the point CPU_PLL_BYPASS it always causes me some problems.
Then there is error handling when writing in nandpro, did you get any errors?