Well today before reading up on anything I went to get into my Netflix and was prompted for a dash update. I figured what tha hell and let it do its thing. At the very end my console went to reboot and nada. it wont boot even to the retail dash. I then started reading and found that some said the CB was updated to a 2 part CB now on Fats and that they weren't sure on the Slims. Well I can confirm the CB has changed and I am not sure if that means the Glitch board will need new timings or what but I think I will have to unhook the Glitch board now just so I can load my stock dash. below is a pick of my old dash and CBs and the new dash I got today.

Would there be any way, if you already had an older NAND and CPU key that you might just be able to flash the old NAND back?

I'm not entirely sure. I tried old nand with correct LDV Values for the glitch and no luck yet. Trying now to just get it to load the original dash again.

I got my original dash working again. If you have the Glitch Board powered on with the original stock dash now it will not boot. I removed the power wire on the Glitch Board and it fired right up on my Stock Dash.

Hey Antman....

I too fell into the same trap and my RGH dual boot is now dead! Let me know when you have a fix for yours as I would hate to lose this console due to my stupidity!

I have seen the guys at Xecuter seem to have "fixed" the 14717 update but I can't tell whether this fix needed to be applied before the 14717 update was run or after?

Thanks in advance for all your posts thus far.... love your work!