Hello,

I have moded my Xbox with The coolrunner and nand-x.

1. Read nand twice and compare it
2. Created The ccs
3. Programed The coolrunner
4. Wired the coolrunner
5. programd the controller with The ccs

Booted up my box but no signal

Cooleunner power led is turned on and one is blinking..

What could be The problem to look into?

If i disconect The coolrunner and flash back The nand my Xbox wil boot.

ccs? you mean ecc? What did you use to create the ecc file?

sorry it was a indead a ecc file (image_00000000.ecc)

I have used 360_Multi_Builder_v0.4 to create this file with option 1 and flased it with nand pro 3

have found a new version 0.7 .. but same result

- 1 Coolrunner LED burns
- 1 Coolrunner LED blinks
- Led from colsole burns also

No signal/booting on TV with AV cable.

Coolrunner switches are on Slim and Normal (have bin there all the way) have also switched the switched to phat ans slim ..

Have some pics:

http://www.mijnalbum.nl/Album=PHMIWEBQ

I have made a fix because of al failure between FT3N2 and R3B15 because of a defect line ..

Xbox boot fine (normale without the coolrunner and default nand)

nobody?

Have installed The 68nF (GND- and now it boot into the Xell!

Normal boot takes aprox 1minute i have seen that i have to modify The wirering places...

Get the slim_post qsb
http://www.xconsoles.com/products/Xecuter-...x-360-Slim.html
Every slim is different. Try all the different lengths and see which one makes it boot fastest.
it really does help. i had a slim that was booting 2-20 seconds.