I tried to update my Nand to Dash 14699 using Nand Flasher 360. Everything seemed to go ok and i never received any error messages that i know of.
On turning off my Xbox and turning it back on i found that there was no picture on the screen and after 20 secs three red lights would flash.
I'm taking it that the flash went wrong, but i have no way to access the system to reflash my last working JTAG Nand that i saved.
My system is fitted with a LPT port but i have no way to connect to my P.C. as it was pre JTAG'ed when i purchased it and i have no printer port on my Laptop.
It was suggested that i purchase and fit a Nand-X as this would mean i could access the Nand chip via a usb port which would be easier.
Form there i was told that all i would need to do is reflash the nand with the last working JTAG Nand image i have, but is it really that easy?
I'm just worried that if not then my Xbox is no longer at a dash that JTAG can be run on if i were to start over, or is it that once an Xbox has been JTAG'ed it can be re JTAG'ed no matter what dash you are on.
I'm not very up on all of this thus why i purchased my Xbox with the JTAG already installed, but i can do what's needed if guided so any help would be great