hi i was wonder why kind of switch i need to get to shut off the xyba light mod. I just don't want to pull out the battery pack out all the time. Thanks

what kind of light mod do you have?
what kind of board do u have?

and.. just a shot in the dark.. sub what it shows for your circuit.. (thanks 2 niktronix)

http://www.niktronixonline.com/Controller_Dome_Mode_s/67.htm

im using a matrix wireless controller and the power source is from the battery pack. Mod is http://www.llamma.com/xbox360/mods/xbox%20...0abxy%20buttons

Looks like llamma connects to the rumbles..

Scroll down to the end of this.. http://www.niktronixonline.com/Articles.asp?ID=150

(like i told you before)

Use the positive and negative of your circuit, and use your brains..

If you want to be spoon fed im not the one... I follow tuts and thats the one i used to shut off my circuit.

Maybe RDC or another knowledgeable member will assist you otherwise..

i dont want the rumbles as the power source. Then it will only turn on when the rumble is going on. But thanks anyways i look into more.

dood.. are u dense? i said llamma did it by the rumbles.. did you c the tut i spoon fed you... its not by the rumbles...

i just want to know what type of switch i would need when im playing in the day and want to shut off the lights when im playing. That transistor on/off is when you shut off the controller.

Micro SPST, I have seen them mounted under the battery packs. Just turn switch on or off before powering on controller.

ah i c.. should have said that from the start...