I installed my x2lite+ and flashed it with ozxflash then i flashed it with the slayers auto-install v2.1 which upgraded the flash to 4976. I went to install evox,xbmp and apps. slayers auto-install then said done. I restarted my xbox and the regular MS dash came up. i tryed all the different installs on the slayers auto-install they say done but the dashboard never loads.

try it again. see if it boots up with slayers again... if it dont you did a pure solder job.

Slayers disc boots but when i install evox,xbmp and apps for the slayers disc my xbox does not boot into evox.

you did what again? try to boot from slayers or just power up the system? cause i said use the media again. if it does not with the Slayers then check your solder points.

I start up the xbox, xecuter shows under the xbox logo. Slayers disc loads up when i am in the slayers menu i choose install/upgrade evox,xbmp and apps. The progress bar pops up says done i restart the xbox but evolutionx dashboard doesnt run. The regular MS dashboard pops up.

Do i need to change xboxdash.xbe to run evox.

Is your evox dash called evoxdash.xbe? this is what the new x2 bioses are looking for on the c: drive

Yes its evoxdash.xbe do i pose to name the MS dashboard to msxboxdash.xbe.